Thumb sans titreThumb sans titreThumb Cowpers HF6Thumb Blast furnace tilt shift - coal conveyerThumb Blast furnace tilt shift - rails

Cowpers HF6

Cowpers

Un cowper moderne consiste en cylindre vertical en acier de 6 à 9 m de diamètre et s'élevant à 20 à 35 m. Cette enceinte est remplie de briques réfractaires dont la nature dépend de leur rôle : on a des briques isolantes qui protègent la face interne du blindage du cowper, et des briques stockant et restituant la chaleur. Ces dernières servent à la construction du puits de combustion, où se déploie la flamme, et du rûchage, un empilement de briques perforées qui absorbe la chaleur des fumées. Le puits est souvent intégré dans le cylindre où il occupe environ un tiers de la section du four. Les plus gros cowpers sont dotés de puits externes qui permettent de mieux isoler la zone de combustion de celle d’accumulation/restitution de chaleur.

La chauffe étant plus lente que le refroidissement, chaque haut fourneau est doté de trois, parfois quatre, cowpers passant alternativement dans chaque phase. En fonctionnement continu, un cowper restitue sa chaleur pendant environ 30 min, avant que le vent soit orienté vers le cowper qui vient de finir une réchauffe de 50 min (durée à laquelle il faut ajouter les phases d'inertage et de mise en pression, qui durent 10 min).

Un cowper moderne peut réchauffer environ 1,4 tonne de vent à 1 200 °C, par tonne de fonte. Lorsqu’il restitue sa chaleur, c'est donc, pour un haut fourneau produisant 6 000 t de fonte par jour, un four d'une puissance d'environ 100 MW. La chauffe est effectuée par combustion d'une partie du gaz produit par le haut fourneau, qui doit être mélangé avec un gaz riche pour atteindre les températures souhaitées.

Source: Wikipedia

Modern cowper consists in vertical steel cylinder 6 to 9 m and a diameter amounting to from 20 to 35 m. This enclosure is filled with refractory bricks whose nature depends on their role has insulating bricks that protect the inner face of the shield cowper, and storing and reproducing bricks heat. The latter are used in the construction of wells combustion, where the flame spreads, and rûchage, a stack of perforated bricks which absorbs heat of the fumes. The well is often integrated into the cylinder where it occupies about one third of the furnace section. The biggest feature cowpers outer wells to better isolate the combustion zone of the accumulator / heat delivery.

Heating is slower than cooling, each blast furnace has three, sometimes four, stoves passing alternately in each phase. In continuous operation, cowper restores its heat for about 30 minutes before the wind is facing cowper who just finished a 50-minute heats (time at which there are the phases inerting and pressurization, lasting 10 min).

Modern cowper can warm wind of about 1.4 tons to 1200 ° C, per ton of pig iron. When the heat returns, so this is for a blast furnace producing 6000 t of pig iron per day, a furnace with a capacity of approximately 100 MW. The heater is powered by combustion of part of the product through the furnace, which must be mixed with the rich gas to achieve the desired gas temperature.

14 favorites and 2 comments

favorites
  • angéliquem1 sur flickrangéliquem1 (Angélique M)
  • Card Collector & HobbyPhotographer sur flickrCard Collector & HobbyPhotographer (SixDecadesMan)
  • claude lina sur flickrclaude lina (Claude)
  • eLe_NoiR sur flickreLe_NoiR (eleonora castagnozzi)
  • FERY Anthony Photographie sur flickrFERY Anthony Photographie
  • jukz sur flickrjukz
  • olemoberg sur flickrolemoberg (Ole Steffensen)
  • OwenGT3 sur flickrOwenGT3 (Owen Wright)
  • Parzival- sur flickrParzival- (Parzival)
  • Raf SG sur flickrRaf SG (RAPHAEL GONZALEZ)
  • TanieBlue sur flickrTanieBlue (Tanie Blue)
  • Vanwetswinkel Vincent sur flickrVanwetswinkel Vincent
  • Whitney Lake sur flickrWhitney Lake (Whitney Lake)
  • ꟼarziʌal sur flickrꟼarziʌal (Parzival)
comments
  • > sur flickr<< Eric B >> (Eric B) -
    Cool industrial mood, i like it!
  • Yamabxl sur flickrYamabxl -
    c'est géant

Location

World map

Metadata

You can also view metadata statistics graphically.

Photo albums

View all albums as cover photo or as simple text links

8 tags

English translation

You have asked to visit this site in English. For now, only the interface is translated, but not all the content yet.

If you want to help me in translations, your contribution is welcome. All you need to do is register on the site, and send me a message asking me to add you to the group of translators, which will give you the opportunity to translate the pages you want. A link at the bottom of each translated page indicates that you are the translator, and has a link to your profile.

Thank you in advance.

Document created the 31/01/2014, last modified the 20/07/2020
Source of the printed document:https://www.gaudry.be/en/photos/set-ironworks-and-blast-furnaces/164367820161696781206016.html

The infobrol is a personal site whose content is my sole responsibility. The text is available under CreativeCommons license (BY-NC-SA). The photos are under Creative Commons license (BY-NC-ND).More info on the terms of use and the author.

No cache version.

Caching disabled. Default setting for this page:enabled (code LNG204)
If the display is too slow, you can disable the user mode to view the cached version.